济南德成铝业有限公司
联系人:李经理
手机:15614693658
电话:0531-87887788
地址:济南市平阴县翠屏街东首
当前位置:首页-新闻资讯新闻资讯
铝板生产厂家教你折弯R角知识
2017-6-30 18:44:11

1.折弯R角的大小。

1. bend R angle size.

铝板生产厂家折弯R角越大,那成功率就越高,所以尽量调大折弯R角越大。

Aluminum plate manufacturer bending R angle is bigger, that success rate is higher, so as much as possible big bend, R angle is bigger.

2.铝板纹路方向。

2. aluminum plate, grain direction.

折弯方向要与铝板纹路方向垂直,不能平行。

The direction of bending should be perpendicular to the direction of the aluminum plate and not parallel.

3.铝板的硬度。

3. hardness of aluminum sheet.

铝板硬度太高,很容易断裂。这就要求选择好铝材,主要看铝材牌号和状态。一般1系列、3系列、5系列的比较常用;6系列、7系列的硬度太高,要先做退火处理到O态后才好折弯。还有就是铝板的质量,相同型号的铝板进口料就比国产料不容易开裂,但材料的价格也是贵了不少。

铝卷生产厂家

The hardness of aluminum plate is too high to break easily. This requires a good choice of aluminum, mainly to see the aluminum brand and status. General 1 series, 3 series, 5 series of more commonly used; 6 series, 7 series of hardness is too high, should first do annealing treatment to O state only after bending. There is the quality of aluminum plate, the same type of aluminum plate, imported materials than domestic materials are not easy to crack, but the price of materials is also a lot of expensive.

4.铝板的厚度。

Thickness of 4. aluminum plate.

太厚的铝板不好折弯,大家一想就明白,尽量使用薄一点的铝板。

The thick sheet of aluminum doesn't bend well, and everyone wants to see how thin the aluminum sheet is.

5.需要拉丝的铝板零件,在工序允许的情况下最好是折弯后再拉形,否则会增加折弯断裂的概率。

5. aluminum parts need drawing, in the process allows, it is better to bend and then pull, otherwise it will increase the probability of bending fracture.

本文由铝板生产厂家为您提供,我们的网站是:http://www.jndcly.com/我们将以全心全意的热情为您提供更优质的服务,欢迎您的访问!

This article by the aluminum plate manufacturer provides for you, our website is: http://www.jndcly.com/, we will wholeheartedly wholeheartedly provide the higher quality service for you, welcome you to visit!